Acer R920 User Manual download pdf (Page 99)

To remove DIMMs on the memory board:

Before you can install a new DIMM in a socket, remove first any

previously installed DIMM from that socket.

Important: Before removing any DIMM from the memory board,

make sure to create a backup file of all important data.

Caution! Use extreme care when removing DIMMs. Too much

pressure can damage the connector. Apply only enough pressure

on the plastic levers to release the DIMM.

1 Perform steps 1 to 3 described in the “To install DIMMs in the

memory board” section.

2 Press the holding clips on both sides of the DIMM slot outward to

release the DIMM.

3 Gently pull the DIMM upward to remove it from the socket.

4 Install the memory board assembly. For instructions, see “To install

the memory board assembly” section on page 76.

5 Observe the post-installation instructions described on page 40.

To reconfigure the system memory:

The system automatically detects the amount of memory installed. Run

the BIOS setup to view the new value for total system memory and

make a note of it.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 205 206

No comments

Acer R920 User Manual Page 99