Acer K272HUL User's Guide download pdf (Page 15)

English

Connecting the power cord

• Check first to make sure that the power cord you use is the correct type

requir

ed for your area.

• The monitor has a universal power supply that allows operation in either

100/120 V A

C or 220/240 V AC voltage area. No user-adjustm

ent is

requir

ed.

• Plug one end of the power cord to the AC inlet, and plug the other end

into an AC outlet.

• For units using 120 V AC:

Use a UL-listed cord set, type SVT wire and plug rated 10 A/125 V.

• For units using 220/240 V AC:

Use a cord set consisting of H05VV-F cord and plug rated 10 A/250 V. Th

cord set

should have the appropriate safety approvals for the countr

y in

which

the equipment will be installed.

Power saving

The monitor will be switched to "power saving" mode by the control signal

from the display controller, as indicated by the amber-colored power LED.

The power saving mode will be kept until a control signal has been detected or

the keyboard or mouse is activated. The recovery time from "power saving"

mode back to "on" is around 3 seconds.

Display Data Channel (DDC)

To make installation easier, so long as your system supports the DDC protocol,

the monitor is able to plug-and-play. The DDC is a communication protocol

through which the monitor automatically informs the host system about its

capabilities; for example, supported resolutions and corresponding timing. The

monitor supports the DDC2B standard.

Mode LED light

On Blue

Power saving Amber

Downloaded from ManualMonitor.com Manuals

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

No comments

Acer K272HUL User's Guide Page 15