3 System upgrade
50
• 2.5-inch hard disk drives must be installed in the following order.
Determining drive status
Each HDD carrier features two LED indicators to display the hard drive
status. If you are replacing a failed HDD, determine which drive has
failed by checking the drive status LED. For more information on how
to determine the drive status, refer to “Hot-plug HDD carrier LED
indicators” on page 26.
To remove an HDD:
1 Observe the ESD precautions described on page 39.
2 Remove the front bezel. Perform the instructions described in “To
remove the front bezel” section on page 41.
3 If you are removing a failed HDD, determine which drive has failed
by checking the drive status LED.
4 Remove the HDD carrier.
(1) Unlock the HDD carrier latch.
(2) Press the HDD carrier latch.
Comments to this Manuals