Acer PCI Disk Array Controller Drivers 08P4100 User Manual download pdf (Page 83)

UnixWare

Manual No. 775079 6-11

3. Rebuild the Kernel:

/etc/conf/bin/idbuild -B ↵

4. Reboot the system:

shutdown -i0 -g0 -y ↵

Changing the Controller Configuration

If there is a need to change the IRQ of the controller at any time, refer to the

UnixWare manual under DCU. If a Mylex Disk Array Controller is the

primary controller, and a second, third or fourth Mylex Disk Array

Controller is to be added, set the interrupt for the secondary controller, then

power-cycle the system (power off, then power on).

When the system restarts, UnixWare identifies the controller and displays

the message “New hardware instance mapped to static driver...” The

controller should be detected automatically during the start up sequence.

Use DCU to verify the interrupts after logging-on the system.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 99 100

No comments

Acer PCI Disk Array Controller Drivers 08P4100 User Manual Page 83