Acer B246WL User Manual download pdf (Page 17)

English

Connecting the Power cord

• Check first to make sure that the power cord you use is the correct type required

for your area.

• The monitor has a universal power supply that allows operation in either 100/120 V

AC or 220/240 V AC voltage area. No user-adjustment is required.

• Plug one end of the power cord to the AC inlet, and plug the other end into an AC

outlet.

• For units using 120 V AC:

Use a UL-listed cord set, type SVT wire and plug rated 10 A/125 V.

• For units using 220/240 V AC:

Use a cord set consisting of H05VV-F cord and plug rated 10 A/250 V. The cord

set should have the appropriate safety approvals for the country in which the

equipment will be installed.

Power saving

The monitor will be switched to “power saving” mode by the control signal from the

display controller, as indicated by the amber-colored power LED.

Mode LED light

On Blue

Power saving Amber

The power saving mode will be kept until a control signal has been detected or the

keyboard or mouse is activated. The recovery time from “power saving” mode back to

“on” is around 3 seconds.

Display Data Channel (DDC)

To make installation easier, so long as your system supports the DDC protocol, the

monitor is able to plug-and-play. The DDC is a communication protocol through which

the monitor automatically informs the host system about its capabilities; for example,

supported resolutions and corresponding timing. The monitor supports the DDC2B

standard.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 28 29

No comments

Acer B246WL User Manual Page 17