Acer AB460 F1 User Manual download pdf (Page 116)

100

101

3 Server Blades: Setup and Installation

3. Loosen the two or four screws (depending on blade type) that

secure the heatsink to the mainboard.

4. Remove the heatsink by

gently

rotating it back-and-forth sideways

with your fingers to release it from the processor. Set the heatsink

aside and upside-down so that nothing comes into contact with

the thermal grease on its underside.

5. Raise the lever of the processor socket up until the processor is

released from the socket, then lift the silver cover plate and

remove the processor.

Warning! This action should only be performed by a

trained service technician.

Installing a Processor

1. If present, remove the protective black PnP cap from the processor

socket.

2. Raise the lever of the processor socket until it reaches its upper

limit (Step 1 below).

3. Lift the silver cover plate completely up and out of the way (Step 2

below).

Note: Be careful not to damage the pins protruding from

the CPU socket.

4. Align pin 1 of the processor with pin 1 of the socket (both are

marked with a small gold triangle) and gently seat the processor

into the socket (Step 3 below).

5. Check to make sure the processor is flush to the socket and fully

seated.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 617 618

Comments to this Manuals

No comments

Acer AB460 F1 User Manual Page 116

Comments to this Manuals