Acer AL1715 User Manual

1 Table of Contents Preface...

10N/A English N/A 繁體中文 N/A Deutsch N/A Français N/A Español N/A Italiano N/A 简体中文 N/A 日本語 Multi-language selection. H. Position Adjust the horizon

11Chapter 3 Technical Information Specifications LCD Panel Size 17" (43 cm) Display Type Active matrix color TFT LCD Resolution 1280 x 1024

12Power Management Mode Power Consumption* AC Input LED Color On 60W maximum 240 VAC Green Off 3W maximum 240 VAC Yellow Soft switch off 3W m

13Standard Timing Table If the selected timing is NOT included in table below, this LCD monitor will use the most suitable available timing. TIMING

14TIMING FH(KHZ) FV(HZ) SYNC POLARITYTOTAL(DOT/ LINE) ACTIVE (DOT/ LINE) SYNC WIDTH (DOT/LINE)FRONT PORCH (DOT/LINE)BACK PORCH (DOT/LINE)PIXEL FOREQ

15Troubleshooting This LCD Monitor has pre-adjusted using factory standard VGA timings. Due to the output timing differences among various VGA cards

2Preface This manual is designed to assist users in setting up and using the LCD Monitor. Information in this document has been carefully checked fo

3Important Safety Instructions Please read the following instructions carefully. This manual should be retained for future use. 1. To clean LCD M

4Chapter 1 Installation Unpacking Before unpacking the LCD Monitor, prepare a suitable workspace for your Monitor and computer. You need a stable

5Detaching LCD Monitor from Its Stand Unscrew screws the swivel base support column and pull down the hinge to release. Figure 1-3 Interface for Ar

6Connecting the Audio Cable (For AL1715 m and AL1715 bm) 1. Connect the audio cable to the " LINE OUT " jack on your PC's audio ca

7Chapter 2 Display Controls General Instructions Press the power button to turn the monitor on or off. The other control buttons are located at fr

8Front Panel Control /Power Button: Press this button to turn the monitor ON or OFF, And display the monitor’s state. Power Indicator: Green — Power

9How To Adjust A Setting 1. Press the MENU-button to activate the OSD window. 2. Press < or > to select the desired function. 3. Press the MEN